Rosemount Measurement
» Micro Motion Prolink II
Back to Discussion Board
|
In Prolink II, the frequency tab, have a failure mode selection which seem not to work with the MVD transmitters. They are None, interrnal 0, Upscale, and Downscale.
|
|
Hi Carl, Welcome to the community!
The Frequency Fault Action is the behavior the frequency output should take when the transmitter is in a critical fault state. If the transmitter has no alarms or only 'non-critical' alarms then the frequency output is not affected by this parameter. Can you verify the transmitter is in a critical fault state (Prolink>Status) and tell us a little bit more about the problem you are seeing? What MVD device and version are you using? How are you measuring the frequency output? This will help us to duplicate the issue. |
|
|